Description
Speed Engineering BMW M2 F87 Brake Cooling
Product description
Producer: speed engineering
Car brand: BMW
Model: BMW M2
Front/Rear Axle: Front
Item number: 13420
Description:
Air duct inlet
In order to transport the air to the exhaust of the brake vent, a suitable inlet is essential. The M2 F87 does not have factory intake ducts in the front bumper like the M2 Competition F87N. What your car does have are 2 coolers on the side behind the bumper! So why not use the existing airflow?
To prevent the air after the cooler from spinning randomly in the wheel arch, we have developed a duct that can be installed with minimal effort and directs the air around the wheel and a connection via a 40 cm long hose (per side) to the exhaust connections leads. Our tests have shown that this does not create significant back pressure behind the radiator and in the case of extreme speeds and increasing pressure, the channels do not create obstacles to the escaping air behind the radiator.
air duct outlet
For many vehicles (including the M2), brake cooling is recommended even under medium loads, even off-track. This not only improves braking performance, but also drastically reduces wear on the friction partners. Our armature plate uses ducting the airflow to the center of the brake disc to use the turbine effect to cool the disc from the inside. We aim the pane at a defined angle to avoid wastage and to use the available air volume as efficiently as possible. Due to the light construction in combination with powdered aluminum, the anchor plate is sufficiently strong and at the same time light and insensitive. In addition, the bearings closest to the brake disc are shielded from the heat,
IMPORTANT: The different models vary slightly in wheel position, in combination with different chassis geometries and wheel and tire combinations, it is impossible for us to cover all variants. In the worst case, the wheel can hit the ground when the steering wheel is turned all the way (which should only be the case when parking), which can not damage the tire. In this case, we ask you to do without the last 1/4 of the handlebars.
scope of delivery
1x Air Duct Inlet Left
1x right air duct inlet
1x Air Duct Outlet Left
1x right air duct outlet
1x air pants 1 meter
6x confirmation
screw
4x hose clamps
This item is suitable for
BMW M2 (non competition/CS)
We also have a suitable kit for the M2C in our shop.
Assembly:
Motorsport24 is the webshop of Chip Performance. We can also assemble your Speed Engineering BMW M2 F87 Brake Cooling for you at a competitive hourly rate. Our workshop is equipped with the latest tools & skilled staff, allowing us to install everything quickly and efficiently.
Chip Performance has a new MAHA MSR test bench where we can measure up to 1500 hp engine power. On request we can do a before and after dynorun so you can see that the installed components are working as specified. Also for Chiptuning en standalone ecus you have come to the right place.
Do you want us to do the assembly? Please indicate this in the order and we will contact you to schedule an appointment.